Step 1: Rivet the nut plates to the E-615 and E-1015 Reinforcement Plates using the rivets called out on Page 9-20, Figure 2

Putting tape over the rivets

Step 2: Back rivet the E-615 and E-1015 Reinforcement Plates to the E-1001B Skins using the rivets called out in the blowup of Figure 1.

Pictured here pulling off the tape. The rivets look real good

Taping the rivets in for the Rib Halves

Step 3: Back rivet all the E-1008 Rib halves to the E-1001 Skins using the rivets called out on Page 9-20, Figures 1 & 2. The correct position of the rib halves on the skins is shown in Figure 1. 

Pulling off the tape after completing the bucking. Back Riveting is producing some very good looking rivets

Step 4: Rivet the E-1007 Rear Spars to the aft flanges of the E-1008B Rib Halves using the rivets shown in the figure. Include the two E-1022 Shear Clips, which share holes with the aft flange of the ribs, when riveting the spars. The spars are riveted to the skins in the next page

.Step 5.  Rivet the remaining E-1022 Shear Clips to the outboard end of the E-1007 Rear Spar.

Step 6: Rivet the E-921 Elevator Gussets to the inboard end of the E-1007 Rear Spars.

Back   Home   Next