| Page 8-11 |
| Step 1: Press
the two SB625-7 Snap Bushings into the 5/8" holes in
the front spar assembly as shown in Figure 1.
|
|
| Step 2: Cleco
the inspar Rib, stringer, and stringer web assembly
(riveted on the previous page) into position on the front
spar assembly. Do not rivet the assembly in place at this
time since it shares rivets with two nose ribs.
|
| Step 3: Except
for the out board HS-904 Inspar Ribs (see figure 1), cleco
the remaining inspar ribs to the front spar assembly. Slide
the HS-1004 Inspar Ribs along the stringers to get them
into position.
|
|
| Rivet these ribs in place using the
rivets called out in the figure. The rivets called out in
the blow up apply to all the HS-1004 inspar ribs except
for the inboard two.
|
|
|