Deburr the edges of the R-1002 and the two R-1007A Striker Plate and Cleco together all the parts shown in the figure 4 (see below)

Final Drill the holes common to the parts using a #30 drill.

Machine countersink the holes of the striker plate for 1/8" Rivets, flush on the forward side

Cleco the R1015A-L and R . Make sure the aft end of the left stiffener is positioned on top of the right stiffener. Final drill the holes in common to the shear clips and stiffeners.

Repeat step 1  for the rest of the R-1015 stiffeners and R-1010 Shear clips

Previous   Home  Next