Wayne Loeber Wing Change
Back to Directory   First airplane

Plans required retrofit of flap mechanism. Location and instruction for installation is shown in Evo Fuselage in Mark's plans. Hope some of these pictures help in changing flap hardware and wing mounting from Hershey wing to the Evo Wing

Old wings removed and ready for new wings

 Pictures shows bushing installation and a Doubler that was added.

Hole location and Doubler clecoed to the outside of the fuselage

Doubler that will be required for strength because of change of rear spar attachment point.

Some supports to reinforce for drilling the side skins

Doubler plate installed

Showing position of bracket that will attach flap motor

Flap motor

Flap motor shown attached to mounting bracket and Flap Torque Tube.

Need cut rear spar and cleanup rear spar attachment from old wing

Moving the new wing into hangar

Unpacking parts

Starting to prep the wing

Fitting Parts

Larry starting to fit large wing fairing

Starting to install Right Wing

Heated Pitot installation

Aileron Bellcrank

Flap Hinges